Here is the latest stable snapshot (the app that's currently on the server): 1.56 rev 372

A couple of things that changed since the last stable version:

- Support for sensors v2.51, v2.52, v3.01. Note that if the sensor is not supported, the app falls back to very basic protocol which results with disabled sensor preferences.
- Sensor revision is returned to the server.
- Minor fixes in the USB code, now the sensor revision is read and printed out to stderr as BCD
- compiled and tested on armv5tel (makefile included), server now supports armv5/Linux 2.6 platform.


The app uses Frank Vanden Berghen's xmlParser to parse preferences.

After two failures (1.61 and 1.62 were broken, while 1.63 was temporary rollback), the Linux app was updated to 1.64.
It brings major change: all the info about sensors (hardware IDs, supported functions) is not hardcoded anymore, it's read from sensors.xml which comes with the app.
This app also reports the vid and pid to server, in the near future it'll be added to the data (also the raw export) - combined with the version ID it fully describes the sensor used.

Why Linux first ? Because the Windows:Linux ratio is about 10:1, so in case of catastrophic app failure 90% of the sensors won't be affected :P
Also, Windows app was partially updated with work-in-progress code some time ago, while Linux was a couple of revisions behind.

Sources: 1.64 rev 440
____________

Current 'stable' release 1.77 sources: 1.77 rev 585
____________